eLine Technology ETV_v7 - Manual (Page 57)

ETV System Server Software - User’s Guide Page 57
Timeout
The number of seconds to attempt to connect to the camera before timing out. If the timeout is
reached, “Signal Loss” displays in the Live Viewer window.
User/Password
The user name and password to connect to the camera. The default values are automatically
entered.
AZTech
Recompress
This will recompress the image using AZTECH codec. This is a CPU and RAM intensive setting.
Fast
Decompression
If the JPG image provided by the HTTP camera supports fast decompression, select this option to
significantly reduce the number of CPU cycles needed for rendering the network camera feed.
Not all network cameras support fast decompression. Disable Fast Decompression if the image does
not display or appears distorted when this feature is enabled.
DIO
If the Network Camera supports DIO, enable the checkbox to automatically add the camera as a
DIO device.
Audio Recording
If the Network Camera supports audio, enable the checkbox and enter a Name for the audio
channel to automatically add the camera as an audio device.
Camera Control If the Network Camera supports PTZ, enable the checkbox to automatically set the PTZ type.
Audio Talk If the Network Camera supports Audio Talk, enable the checkbox to enable audio talk.
Sub Stream
Enable this checkbox to make the Sub Stream from the Network Camera available to applications
that connect to the Server such as VIGIL Client.
Default Settings Changes the network camera settings to their default values.
DVR Network Camera Type
Another DVR can be connected in the same way you would connect to a network camera. This will display any
camera that the DVR receives and allows you to relay analog video from one recording DVR to another.
To set up this configuration, select the Vigil DVR type in the Network Camera window. The recommended
settings for this setup are:
Address IP Address of the VIGIL Server DVR.
Port Live Video Port, default 22802.
Camera Number The camera input number on the remote DVR to be used.
User/Password The username and password used to log into the remote DVR, if applicable.