AT&T 7630 - Manual (Page 26)

2 5
Call Screening
You can uses the cordless handset to listen to callers as they leave messages. You
can speak to a caller by pressing
P.
To monitor a call:
1 If the handset is away from the base, press a.
2 To end monitoring without taking the call, press a or put the
handset in the base.
Recording Outgoing Announcement
1 Connect with the answering system.
2 Press * 7. The system beeps to signal that it's ready to accept a
command.
3 Record your announcement.
4 Press 5 to stop recording. The system beeps and plays back your
announcement, then beeps twice and is ready to accept a command.
Reviewing your announcement
1 Connect with the answering system.
2 Press 7. The system plays your announcement, then beeps twice and is
ready to accept a command.
Recording a Memo
1 Connect with the answering system.
2 Press #, then enter the number of the mailbox where you want the
memo recorded, and begin speaking after the beep.
3 Press 5 when you are finished.
Setting the Clock
1 Connect with the answering system.
2 Press * 8. You will hear the current day, followed by “To change,
press 6 or 4. To change the hour, press 8.”
3 Press 4 to move back a day, or 6 to move forward a day.
4 Press 8. The system announces the current hour setting, followed by
“To change press 6 or 4. To change the minutes press 8.”
5 Press 4 to decrease or 6 to increase hour.
6 Follow the same procedure to change the minutes setting.
7 The system announces the new time setting, then beeps twice to
indicate it is ready to accept a command.
ANSWERING SYSTEM OPERATION
At Cordless Handset or Touch Tone Phone
7630_book.1AT&T 8/12/98, 6:29 PM 25