Arcam DV27A - Manual (Page 14)

14 15
E
n
g
li
sh
P
MODE STATUS SRCH
ZOOM ANGLE SUBT PL
AUDIO TRIM TITLE RTN
RPT CLEAR 0 PROG
A–B 7 8 9
DISP 4 5 6
1 2 3
DVD
CR-415
SETUP MENU
MEM
OK
OPEN
Using the CR-415 remote control
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the
remote control may not work.
DISP (display)
Dims or turns the player’s display on or off. Turning the display off
generally gives a slight improvement in sound quality.
Pressing DISP once turns the display off; twice dims the display. To
restore the display to full brightness, press DISP a third time.
A–B
This button enables you to repeat a selected
section from the disc (see page 16).
RPT (repeat)
Press RPT to cycle through the repeat play options.
CLEAR
Use
CLEAR within the ‘Program’ and ‘Bookmark’ menus to
clear a numeric field (see pages 15–16).
0–9 keypad
This allows direct access to individual tracks on audio CDs. To select
a track, press the corresponding keypad button followed by
OK . For
tracks greater than 9, enter the digits in sequence. For example, to
play track 15, press
1 , then 5 , then OK .
PROG (program)
You can program a selection of up to 20 chapters/tracks
from a disc to play in any order. Press
PROG to access the
‘Programme’ menu (see pages 15 and 16).
MUTE
Stops sound to the speaker outputs of certain Arcam
amplifiers.
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume ( + / – ) controls and MUTE button have
no effect on the audio output level of the DVD players.
OPEN
Opens and closes the disc tray
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD)
and menu pages. Confirm your selection with the OK button.
Playback control
Pause ( ), Play ( ) and Stop ( )
(see page 6).
Fast play and Skip chapter/tracks
Play fast ( ) and Skip ( ) chapters/tracks in
both directions (see page 6).
Advanced controls
These buttons are described on the next page.
Standby
Press
STANDBY to toggle the standby state of the DVD player.
MENU
Press
MENU to access the DVD ‘Disc’ menu.
This navigation menu is specific to a disc and varies for each
title, but typically offers facilities to select chapters, languages,
and view extra material such as trailers or documentaries.
Once the menu has been accessed, use the cursor pad to
move around the menu and press
OK to activate a menu
‘button’.
SETUP
‘Setup’ allows you to configure the DVD player for
use in your system. Ensure that no disc is playing and
press SETUP to access the ‘Setup’ menu.
Page Up/Down (DVD-audio)/Slow play (other discs)
DVD-audio: Some DVD-audio discs allow the user to browse
through images (photographs of the artist, lyrics, etc.) while
music is being played. Use the or buttons to change to
the previous/next page. Note that this is not availble on all
DVD-audio discs.
Other discs: Press or on the remote control to play slow
forward or backwards. There are four speeds of slow playback:
1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle
through the different speeds. To resume normal playback
speed, press
PLAY .
NOTE: Slow play does not apply to audio CDs or DVD-audio
discs.