Fluid Components International CMB - Manual (Page 93)

Errors that are attributable to system memory or software, division by zero, or a fault in the electronics
unit are designated as system errors. These error messages are not reset automatically after the error
(usually of very brief duration) is eliminated. Before resetting a system error manually, we advise that
you contact our technical service department.
For further information, see Section 15.3.1 Display of
self-test errors.
Reset error
[no]
If the operator toggles to [yes] and confirms the action according to the description in Section 12.4.3.1
Selection window/make a selection, the error messages disappears from the display. If the message
reappears shortly after, do contact our technical service department.
13.13.5 Profibus/Modbus device address
Before connecting fieldbus devices to a bus system, the operator must define a device address. This
address is a unique assignment to a participant device in a bus system (similar to a street number).
After selecting the Profibus/Modbus device address, press
↵ to display the set address:
Device address
126
As mentioned in Section 12.4.3.2 Input window/modify a value, the operator can change the displayed
value. After setting the new device address, press
↵ to confirm and apply the change.
CMB & CT OPERATING MANUAL
Part No 06EN003384 rev. 1.6 Page 93 of 106