Hach-Lange ORBISPHERE 410 User Manual - Manual (Page 28)

26
Installation
3.5.2 USB-B client adapter cable
3.6 Connection to mains power supply
3.6.1 Power supply connection (low voltage instruments)
For low voltage instruments (10-30 VDC), connection to the mains power supply is with a 7-pin
BINDER connector (supplied).
Note: The connectors are grooved to avoid an incorrect fitting to the instrument.
Connect the power cable to the connector as follows:
Figure 9 USB-B adapter cable
This supplied cable is needed to connect the
instrument to a PC.
Connect to the instrument, and connect the
USB connector to the USB outlet on the
user’s PC.
Figure 10 BINDER connector
Pin Connections:
2) Power 10-30 VDC
5) Ground
7) Earth
1 + 3 + 4 + 6) Unused