INSTEON KeypadLinc Dimmer, 8 button (2486DWH8) Manual - Manual (Page 16)

Page 16 of 24 Rev: 1/21/2014 7:36 AM
Part 2 Radio Button Groups
1) Tap each radio group button until its LED is Off
2) Press and hold button A until it beeps (about
10 seconds)
3) Tap the Set button (this places the unit in Add
Multiple Responders mode)
4) Press and hold, one at a time, buttons B, C
and D until each beeps
5) Tap the button you started with in step 1 to
end this programming step
6) Repeat steps 1-5 inserting button B into step 2
and all other buttons into step 4
7) Repeat steps 1-5 inserting button C into step 2
and all other buttons into step 4
8) Repeat steps 1-5 inserting button D into step 2
and all other buttons into step 4
9) After ending the last program step, verify your
“Radio” Button Groups by tapping each button
in the group. Each tap should turn On that
specific button in the group and immediately
turn Off any others in the group presently On.
Air Gap
To remove all power from KeypadLinc and connected light(s), pull the Set button at the bottom of the
switch out as far as it will go, about 1/8”. (It might be helpful to use a small screwdriver.) This will open
mechanical contacts creating an Air Gap.
To restore power, tap the air gap back into place, until its top is even with the trim frame.
Factory Reset
Factory Reset clears all user settings from KeypadLinc including INSTEON Scenes, On-Levels, Ramp
Rates, X10 addresses, etc.
1) Pull Set button out (creating an Air Gap)
2) Wait 10 Seconds
3) Push Set Button in and Hold it in
KeypadLinc will (Beep)
~10 sec Beep ~10 sec Beep ~10 sec Beep
Press and release
~10 sec Beep