INSTEON KeypadLinc Relay (2487S) Manual User Manual
Page 7
Page 7 of 25 2487S - Rev: 1/21/2014 7:37 AM
6)
After you have connected all of the wires, ensure that all of the wire connectors are firmly attached
and that there is no exposed copper except for the GROUND wire
7)
Orienting KeypadLinc with the Set button on the bottom, gently place it into the junction box, and
then screw it into place
8)
Enable power to the switch from the circuit breaker or fuse panel
9)
Verify KeypadLinc is working properly by turning the light on and off
10) Reinstall the trim plate
Installation
(for a circuit with more than 1 switch)
If more than one switch controls a single set of lights (called a "load"), the switches are part of a multi-way
circuit. A 3-way circuit (the most common) uses two switches to control the load, a 4-way circuit uses
three switches, and so on.
Here is how a typical wired-in, 3-way circuit (with two switches) works: