Impulse SIO-104+2 (3502) - Manual (Page 9)

Installation
Sealevel Systems SIO-104+2 Page 7
Linux
Refer to D:\software\seacom\Other\Linux\Linux.serial.readme (where D: = your CDROM driver letter) found on
the Sealevel Systems CD. This file contains valuable information on installing your adapter in the various Linux
releases. Also in this sub-directory is the Linux SerialHOWTO. This series of files explains typical Linux serial
implementations, as well as informing the user to Linux syntax and preferred practices.
QNX
Refer to D:\software\seacom\Other\QNX6\Install.readme (where D: = your CDROM driver letter) found on the
Sealevel Systems CD. This file contains valuable information on installing your adapter in the QNX6 Neutrino OS,
as well as the files required to ensure a flawless implementation. Also provided on the Sealevel Systems CD are
implementation instructions for QNX4. These are found in D:\software\seacom\Other\QNX4\QNX_COM.txt.
Physical Installation
Extreme care should be taken when installing the adapter to avoid causing damage to the connectors. After the
adapter is installed, connect your I/O cables. Please note these headers are keyed so that pin 1 of the cable matches
pin 1 of the connector. Refer to Card Setup for information on setting the address and IRQ before inserting the
adapter onto the stack.
1. Turn off PC power. Disconnect the power cord.
2. Remove the case cover (if applicable).
3. Gently insert the adapter noting proper key orientation of the expansion connector on a PC/104 compatible
card. The adapter is keyed per the current PC/104 Specification. This will aid in preventing the adapter
from being inserted incorrectly.
4. Mounting hardware (nylon stand-offs and screws) is provided to ensure a good mechanical connection.
Retain any mounting hardware not used to allow for future expansion.
5. The cables provided are keyed and can be installed before or after the adapter is inserted in the stack.
6. Replace the cover.
7. Connect the power cord and power up the machine.