Laurel Metal 2100 Drop Shelf Vender - Manual (Page 2)

Model 2100 Coin Mechanism
Part #2100-D101
Model 2100 Exploded View Installation
The vender can be mounted on any vertical surface
without removing any part of the unit. Any standard
fastener not larger than 3/8" diameter such as wood
screws, expansion bolts, machine bolts or carriage
bolts can be used depending on the type of wall. The
wall section selected for installation should be sturdy.
The top two fasteners should be loosely installed in the
wall with the heads of the fasteners projecting out
approximately 1/4" from the wall. Raise the top shelf of
the magazine into its vend position to expose one of
the two top mounting holes in the back of the cabinet.
The keyhole shape of the mounting holes will permit
you to hang the cabinet on the two fasteners. While in
this unsecured position, mark the bottom mounting
holes on the wall and remove the cabinet. Install the
bottom two fasteners and secure the cabinet to the
wall using washers under the heads of all fasteners.
Loading
The shelves can be easily and quickly reset into the
vend position (horizontal) by running the index finger of
your right hand up the right side of the shelves. This
“fanning” will take only seconds to reset all 24 shelves.
The top shelf has an automatic empty device that will
cause the coin mechanism to reject all coins when the
vender is empty. Therefore, it is extremely important to
load from the top shelf down if the vender will not be
fully loaded during restocking.
Coin Mechanism Features
The standard coin mechanism in the vender accepts
U.S. quarters and will be factory set to vend at 50¢,
unless otherwise requested. Instructions for changing
the price setting are given under the heading “Coin
Mechanism Instructions”. Whenever the vend price
is set for 50¢, 75¢ or$1.00, a customer can retrieve
his quarters prior to vending by pushing the Coin
Return Button. There is no coin return function when
the vender is set at 25¢; pushing the Coin Return
Button will, however, clear all bent or steel slugs out
of the Coin Acceptor.
Front View of Coin Mechanism
Rear View of Coin Mechanism
Coin Acceptor
2100-29
Spring-Coin
Platform
2100-111
Coin Platform
2100-A109
Coin Return Rod
2100-119
Knob
2100-32
Scavenger Lever
2100-A114
Ratchet
2100-115
Pull Rod
2100-A31
Ratchet Pawl
2100-23
Coin Gate
2100-A112
Bracket-Empty
Lock Rod
2100-106
Link
2100-118
Spring-Ratchet
2100-124
Lock Lever
2100-116
Actuating Pin
2100-33
Number Part # Description
1 2100-12 Actuating Arm
2 2100-D1 Magazine Assembly
3 2100-D101 Coin Mechanism
4 2100-A45 Cabinet
5 2100-127 Empty Lock Rod
6 300-A69 Coin Box w/Lock
7 2100-B125 Door w/Hinge
8 2100-63 Security Frame
9 2100-64 Side Bar
1
2
3
5
8 7
9
4
9
6
Part # Description
2100-55D-U Door Lock - Upper - Key #2101
2100-55D-L Door Lock - Lower - Key #2101
2100-59D-U Door Lock - Upper - Key #2345
2100-59D-L Door Lock - Lower - Key #2345
2100-137 Key - Coin Box - Key #ES203
2100-137D Key - Diaper Vender Door - Key #2101
2100-139D Key - Diaper Vender Door - Key #2345
Model 2100-D Diaper Vender