Tdec, 1 hz, Continued from previous page – Liquid Controls IT300N-BBL User Manual
Page 9: Programming flowchart (continued)
8
PROGRAMMING FLOWCHART
(continued)
Press the
key to step the totalizer decimal to the desired location.
Press the E key to enter the displayed decimal location.
Press the M key to skip and keep the existing location
Press the
key to step to the desired totalizer descriptor.
Press the E key to enter the displayed descriptor.
Press the M key to skip and keep the existing descriptor.
Press the
key to step to the desired scale setting.
Press the E key to enter the displayed scale setting.
Press the M key to skip and keep the existing setting.
Press the
key to step the ratemeter decimal to the desired location.
Press the E key to enter the displayed decimal location.
Press the M key to skip and keep the existing location
TDEC
12345678
ToT DESC
SEC
SCALE
0000
oUT Lo
59999
oUT HI
D 1
PULSEoUt
TOTAL DECIMAL
TOTAL
DESCRIPTOR
SCALE
(ratemeter)
OUT LOW
(4mA)
OUT HIGH
(20mA)
DIVIDER
PULSE OUT
SEC
NNIN
HRS
D 1
D 10
D100
oFF
GAL
LIT
FT3
M3
"blank"
1234
R DECLoC
RATE DECIMAL
LOCATION
D 1
D 10
D100
oFF
RUN MODE
E
M
E
M
E
M
E
M
E
M
E
M
E
M
Continued From
Previous Page
0000
loc code
LOCK
CODE
E
M
yes
loC UnIt
E
M
1 HZ
freq.out
PULSE
OUTPUT
FREQUENCY
E
M
1 H2
2 H2
4 H2
8 H2
Press the
key to increment each individual digit of the out low setting
(4mA value). This will only display on units with Analog Output.
Press the
key to advance to the next digit.
Press the E key to enter the displayed value.
Press the M key to skip and keep the existing value.
Press the
key to step to the desired divider for the pulse output.
Press the E key to enter the displayed divider.
Press the M key to skip and keep the existing divider.
Press the
key to increment each individual digit of the out high setting
(20mA value). This will only display on units with Analog Output.
Press the
key to advance to the next digit.
Press the E key to enter the displayed value.
Press the M key to skip and keep the existing value.
Press the
key to step to the desired frequency for the pulse output.
Press the E key to enter the displayed frequency.
Press the M key to skip and keep the existing frequency.
This will not display if Pulse Out is turned OFF.
Press the
key to increment each individual digit of the lock code.
Press the
key to advance to the next digit.
Press the E key to enter the displayed value.
Press the M key to skip and keep the existing value.
Press the
key to step to the desired lock setting.
Press the E key to enter the displayed lock setting.
Press the M key to skip and keep the existing setting.