Mach III Clutch X6A2G-STH User Manual
Page 5
7/9/2013
CLUTCHBR_SHAFT_BALLBRG_MANUAL
Page 5 of 5
D. REASSEMBLY
(1)
Replace the piston/bearing/cone sub-assembly into cylinder.
(2)
Inspect the inside diameter of the bearing in the air cylinder. If Loctite
®
residue is
present, gently scrape and assure that the surface is clean.
(3)
Apply a thin coat of Loctite
®
#609 retainer compound to the inside diameter of the
cylinder bearing, then slide the air cylinder/bearing sub-assembly over the drive hub.
Applying excessive Loctite
®
will make future disassembly more difficult.
(4)
Replace the outer retainer ring. Invert clutch-brake and seat cylinder sub-assembly
firmly against retainer ring.
(5)
Replace drive discs, friction discs and springs according to “CLUTCH & BRAKE
FRICTION DISC & SPRING REPLACEMENT
” portion of these instructions.
(6)
Replace the sleeve and retainer rings. Repeat instructions 2 & 3 above regarding
Loctite
®
.
(7)
See “CLUTCH INSTALLATION” portion of these instructions for the proper procedure
for reinstalling the clutch-brake.
Technical assistance is available by contacting Mach III Clutch, Inc.
Mach III Product Warranty
Mach III Clutch, Inc.
101 Cummings Drive ● Walton, KY 41094
Toll free 866.291.0849 ● International 859.291.0849 ● Fax 859.655.8362