Magnum Venus Plastech UltraMAX Pre-Start Checklist - Manual

ACTIVITIES MUST BE DONE IN THE SEQUENCE SHOWN, AND MUST BE CHECKED OFF AS COMPLETED. USE
THIS CHECKLIST IN CONJUNCTION WITH THE OPERATING MANUAL FOR THE ULTRAMAX UNIT.
THE UNIT IS NOW READY TO BE STARTED UP. GO TO CHECKLIST 02 – START UP
ABNORMAL CONDITIONS OBSERVED AND CORRECTED
OPERATORS NAME _______________________________________ DATE: ________________
SIGN OFF WHEN PRE-START CHECKS ARE COMPLETED : _____________________________
UltraMAX™ Pre-Start Checklist
ACTIVITY
NO.
ACTIVITY  WHEN
COMPLETED
Priority Put on Respirator as specified for spray
painting, Protective Clothing, Eye Protection,
and PVC Gloves
1 Tools and materials are available for pre-start
checks.
2 Incoming airline is ½ inch.
3 Incoming airline is connected to the inlet manifold.
4 Earth straps are connected to the resin drum and
to earth.
5 Incoming air valve is in the OPEN position.
6 Air supply is ON.
7 At the Manifold, open the air supply to the gun.
8 Seat the catalyst and resin seals on the ProGun.
9 Compress the resin pump packing.
10 Check for oil in the pump reservoir.
11 Adjust the Catalyst Pump Packing Nut.
12 Check that there is Catalyst in the Catalyst Bottle.
13 Check that the Catalyst Bottle Cap is in place.
14 Place the Resin Pick-up wand in the resin supply
container.
15 Place the end of the Resin Return Hose in the
resin container.
16 Fill the Solvent Flush Tank.
17 At the Manifold, turn the Air Pressure on to the
Solvent Flush Tank (50
– 60 psi)
18 Flush the mix chamber on the ProGun.
19 Remove air from the Catalyst feed line to the
Catalyst Pump.
20 Close the ball valve below the Surge Chamber.
Abnormal Condition
 when
corrected