Dixon Valve 5111A Brass Ferrule Crimper - Manual (Page 2)

Dixon, 800.355.1991 2 5111A_sales-413
DESCRIPTION:
The 5111A Ferrule crimper is hand operated. It is used in a fixed location for small production
runs, or mounted on a carrier as a mobile hose repair unit.
The 5111A crimper is designed for the production or repair of hoses using light or medium weight
ferrules and stems for air or water hose.
INSTALLATION:
The 5111A ferrule crimper is shipped fully assembled, (except for installing handle), less crimping
dies. It should be secured to a bench or carrier.
MAINTENANCE:
The 5111A ferrule crimper is greased at time of assembly. Periodic inspection, cleaning and greas-
ing of all moving parts is necessary (use a WD40 type spray).
OPERATION:
1. Install proper stem and ferrule onto hose.
2. Place assembly into opening between the crimping dies and pull handle No. 8 until crimping
dies contact ferrule. A steady pull on the handle will bring the dies through center completing
the crimping operation.
INSTRUCTIONS FOR USE OF
5111A FERRULE CRIMPER