Dixon Valve 25 TON RAM SEC05 Converting - Manual (Page 3)

25 Ton Ram Instruction Manual Converting from Swaging to Expansion
customer service 800 • 355 • 1991 2 Section 5
While lifting up on the 25IXATTACH, tighten the
bolt by hand in the main Ram pusher plate until it is
snug.
Note: To make this step easier, stand in front of the
ram and place one foot on the cross bar closest to
you. Place you knee under the 25IXATTACH and
lift up. Tighten the bolt by hand until it is snug.
Install the 25IXATTACH by aligning the large hole
with the slotted guide to the retaining bolt and
washer. When installed the 25IXATTACH will hang
freely.
Loosen the retaining collar and allow the guide plate
to slide down and fit into the die holder. Secure die
holder and guide plate with keeper plates. Tighten
evenly or else the Ram will jam.
Install Die Holder DH9-004.
7
6
8
5