Asus P4BP-MX - Manual (Page 53)

ASUS P4BP-MX 2.0 motherboard 2-21
Hot Key Power ON [Ctrl-F1]
Allows you to set a hot-key to wake up the system from sleep mode. To configure
this item, make sure that the Power ON Function is set as Hot KEY.
Configuration options: [Ctrl-F1] ... [Ctrl-F12]
PWRON After PWR-Fail [Off]
Allows you to set whether the system will reboot after power interruptions.
Configuration options: [Off] [On] [Former-Sts]
Run VGABIOS if S3 Resume [No]
Sets whether to run the VGABIOS after an S3 resume.
Configuration options: [Auto] [Yes] [No]
Power Button < 4 Sec [Instant-Off]
When set to Instant Off, the system will go to soft-off after the power button is
pressed for less than 4 seconds. When set to Suspend, the system will go to
suspend mode after the power button is press for less than 4 seconds. Press the
power button for more than 4 seconds to power-off the system.
Configuration options: [Instant-Off] [Suspend]
Wake-Up by PCI card [Enabled]
Disables or enables the PME to generate a wake event from soft-off mode.
Configuration options: [Disabled] [Enabled]
Power On by Ring [Disabled]
Disables or enables the wake event from soft-off mode when the external modem
receives a call. Configuration options: [Disabled] [Enabled]
Resume by Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake event. When this item is
enabled, the Date (of Month) Alarm and Time(hh:mm:ss) Alarm fields are
activated for manual setup. Configuration options: [Enabled] [Disabled]
Date (of Month) Alarm [0]
To set the data of alarm, highlight this item and press <Enter> to display a pop-up
menu. Key-in a value within the specified range then press <Enter>.
Configuration options: [Min=0] [Max=31]
Time (hh:mm:ss) Alarm [0:0:0]
To set the time of alarm:
1. Highlight this item and press <Enter> to display a pop-up menu for the hour
field.
2. Key-in a value (Min=0, Max=23), then press <Enter>.