PASCO PS-2205 Dual Load Cell Amplifier - Manual (Page 5)

®
Model No.PS-2205 Technical Support
5
The condition of the signal coming from a load cell on pins 5 and 6 determine how the
DataStudio program recognizes the range of the load cell that is attached. If you are
using a non-PASCO load cell, then either or both Range Select pins of the load cell
must be connected to ground in order for the Dual Load Cell Amplifier to report a
load cell reading.
Technical Support
For assistance with any PASCO product, contact PASCO at:
For more information about the Dual Load Cell Amplifier and the latest revision of this
Instruction Sheet, visit:
www.pasco.com/go?PS-2205
Limited Warranty For a description of the product warranty, see the PASCO catalog. Copyright The
PASCO scientific 012-10888A Dual Load Cell Amplifier Instruction Sheet is copyrighted with all rights
reserved. Permission is granted to non-profit educational institutions for reproduction of any part of this
manual, providing the reproductions are used only in their laboratories and classrooms, and are not
sold for profit. Reproduction under any other circumstances, without the written consent of PASCO sci-
entific, is prohibited. Trademarks PASCO, PASCO scientific, DataStudio, PASPORT, Xplorer, and
Xplorer GLX are trademarks or registered trademarks of PASCO scientific, in the United States and/or
in other countries. For more information visit www.pasco.com/legal. Windows is a registered trademark
of Microsoft Corporation in the United States and/or other countries. Mac is trademark of Apple Com-
puter, Inc., registered in the U.S. and other countries.
Patents Pending The following PASCO products have patents pending:
Product End of Life Disposal Instructions:
This electronic product is subject to disposal and recycling regulations that vary by
country and region. It is your responsibility to recycle your electronic equipment per
your local environmental laws and regulations to ensure that it will be recycled in a
manner that protects human health and the environment. To find out where you can
drop off your waste equipment for recycling, please contact your local waste recy-
cle/disposal service, or the place where you purchased the product.
The European Union WEEE (Waste Electronic and Electrical Equipment) symbol (to
the right) and on the product or its packaging indicates that this product must not be
disposed of in a standard waste container.
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Phone: 916-786-3800 (worldwide)
800-772-8700 (U.S.)
Fax: (916) 786-3292
Web: www.pasco.com
Email: [email protected]
ME-6990 Truss Set PS-2198 Load Cell Amplifier
ME-6991 Bridge Set PS-2199 Load Cell and Amplifier Set
ME-6992 Advanced Structures Set PS-2200 100 N Load Cell
ME-6995 Road Bed Spares PS-2201 5 N Load Cell
*Load cells with
other ranges such as
± 1,000 N may be
available in the
future. Check the
PASCO web site for
further information.