FEC AFC1200 - Manual (Page 3)

)(& ,QF
Fastening method, tool type, and fastening parameters.
2) SPEED Speed and duration (time or revolutions) of preset (normally
CW) rotation.
3) REVERSE Speed, duration (time or revolutions), and angle of reverse
7.0.1 normal Operation
if the System's preset data is already configured for machine operation, no further setup is
required. To choose the display screen you wish to view, proceed as follows:
1. The cursor on the menu bar is shown as a purple highlight. Move the cursor to "MENU"
using the keypad
[←] [→]
keys, and then press the
[↵]
key. "DISPLAY MENU" will
appear and show the existing display screen in a cyan colored highlight.
2. Use the keypad
[↑] [↓]
keys to select the desired item, and then press the
[↵]
key to
change to the display screen for the selected item. The (Main) Menu pULLDOWN is
shown in Figure 7-0-1.
FIG. 7-0-1 (Main) MENU PULLDOWN
Details are given for each Menu pulldown option in the following Sections of this Chapter. To
assist in locating topics, this Chapter has been broken into Sections numbered in accordance
with the Menu pulldown line item number. For example: To find procedures in this Chapter
for the Data File Utility screen, note that it is numbered as "13" on the Menu pulldown.
Therefore, the Data File Utility screen is the subject of manual Section 7.13, with "7"
indicating the Chapter number. The purpose of each screen is outlined below.
7.1 SET PARAMETER: THe functions of these screens are to input the fastening
method, the tool type, and all of the fastening, speed, and
reverse parameters.
1) FASTENING
Chapter 7: System Operation
Page 7-3