General Tools and Instruments DCS050 - Manual (Page 5)

SETUP
HARDWARE
Before using the Seeker050 or the Seeker050-09, make sure to remove the rubber cap
that protects the camera and LEDs on the end of the probe.
ACCESSORIES
To attach any of the three 12mm accessories that come with the DCS050, slip the
semicircular end over the flats of the camera head and rotate the accessory 90° until it
snaps into place.
Attach the 9mm accessories to the Seeker050-09 probe by screwing them on to the tip
of the probe.
SOFTWARE
ScopeView Installation Instructions
1. Insert the ScopeView mini-disk in your computer’s CD/DVD drive and close the
drawer. After the CD loads, the “Welcome to the ScopeView Setup Wizard” screen will
appear. Click Next to continue.
2. Read the End-User License Agreement and accept its terms by checking the box at
lower left and clicking Next.
3. On the Custom Setup screen that appears next, note the advisory that ScopeView will
be installed in the Program Files folder of your computer’s C drive by default. This is
the recommended location. Unless you want ScopeView to be installed elsewhere on
your computer, click Next.
4. On the screen that appears next, click Install to begin the installation.
5. The next screen that appears is a Windows User Account Control dialog box. Respond
to the question, “Do you want to allow the following program from an unknown
publisher to make changes to your computer?” by clicking “Yes”.
6. When the notification, “Completed the ScopeView Setup Wizard” appears, click Finish.
7. Show your desktop. Note that the installation has placed a icon on your desktop.
Also note that a ScopeView folder containing applications, application extensions and
drivers has been added to your Program Files folder.
8. Open ScopeView. Check that the text “USB Camera” (for Windows7 computers) or
“USB Video Device” (for Windows XP computers) appears in ScopeView’s Device
window (the third item from the left on its toolbar). If you are using a laptop computer
equipped with a video camera, the camera is likely to be the default device. Using the
pulldown in the Device window, deselect the laptop camera, select either USB Camera
or USB Video Device, and click
(the tab to the right of the Device window).
5