General Tools and Instruments DCS1800 - Manual (Page 11)

User Guide 0 User Guide 
Troubleshooting
1. Unable to turn on the console
Users will not be able to turn on the console when the battery is very low or empty. Please
recharge before use.
2. Can turn on the unit but the image does not appear on the monitor
Please check the insertion tube connector or simply re-connect the insertion tube to
correct the problem.
3.Unable to capture photos/video
Please check the status of the SD card. Users will not be able to capture photos or video if
the SD card is not installed properly or if it is full, write protected or damaged.
Insertion Tube Maintenance
1.To avoid danger, please do not put the insertion tube into any flammable liquid or gas.
2.The insertion tube contains a series of small wires that control the optics and electronics of
the camera tip. To ensure long-term reliability, do not bend the insertion tube more than
180 degrees, and always bend the insertion tube in as large an arc as possible during
usage and storage.
3.Camera Lens cleaning
User may clean the camera lens with a cotton swab and small amount of cleaning naphtha
Cautions for Use
- Do not remove the SD card during capturing photos or video. This can cause a loss of the
image or video and may damage the SD card.
- Video recording requires an SD card with fast writing speed. We recommend 80X (or above)
writing speed SD cards for better video quality.
- The DCS1800 is designed for industrial purposes only. Do not use the system for human or
any other biological inspection.
- Do not insert the insertion tube into any flammable gas or liquid (such as a fuel tank) to
avoid dangers.
- Do not use the
DCS1800 in a fuel tank or other dangerous environment such as a gasoline
or alcohol storage tank.
- Do not use any corrosive liquid for cleaning, such as alcohol.