General Tools and Instruments DCS400/DCS400-05/DCS400-09 v.1 - Manual (Page 14)

Fig.10
#2
Video Out
#3
USB Port
#4
SD Memory
Card
#5
Monitor
Charging Port
#6
Bi-Colored
Charging Light
#1
Power Button
(on top)
The right side of the LCD monitor (Fig.10) houses the controls and connections
you will use to view, record and upload your images as well as charge the unit
(Fig.7). To start with, the button on the top right of the unit (#1) performs two
functions. When it is pushed and held for 3+ seconds, it turns the display ON
and OFF. When it is pressed only briefly (after the unit has been powered up),
it toggles the unit’s operating mode between live viewing and recording with
playback of pictures and videos.
On the right side of the monitor are the jacks needed to plug in the video
cable (#2) “Video out”, the USB cable (#3) , the Micro SD memory card (#4),
the charging port (#5), and the bicolored charging light (#6).
VIEW AND RECORD IMAGES MODE
In the “live viewing/recording” mode the controls have the following func-
tions:
1. Pressing the left black button (#9) takes a still picture (in .jpg format).
2. Pressing the right black button (#10) begins and ends the video recording.
3. Pressing the left yellow button (#7) inverts the screen image 180º.
4. Pressing the right yellow button (#8) enlarges the screen image on the
display by up to 4 times. Each time you press this button, the image gets
larger by a factor of 0.2 up to 4x. A readout on the bottom of the display in-
dicates the current zoom level.
14