Cquisition settings options in, Nergy mode – Gentec-EO PC-Gentec-EO (for MAESTRO and INTEGRA) User Manual
Page 16

PC-Gentec-
EO User’s Manual Revision 5.0
15
3.1.2.3.2 Set your Acquisition parameters in Energy Mode
In Energy Mode, you can use the
“Set Acquisition” tab to choose the sample rate and duration of an
acquisition. The sample rate is defined to measure 1 pulse every X pulses (for example: 1 measurement
every 10 pulses). The total duration is also set in a specified number of pulses. The filename for data
logging, the file location and the option to add a timestamp to each value can also be set using this menu.
Fig. 3-7 Acquisition settings options in Energy mode
Warning
The number of pulses acquired is the number of pulses that the PC-
Gentec-EO received via the USB port. Depending on the device, this can
be different from the number of pulses received by the monitor. Please
refer to the specifications in section 1.2.
For the MAESTRO, the repetition rate is limited to 500 Hz, the MAESTRO
will perform a subsampling. If you need to make an acquisition using all
the points measured by the MAESTRO, please use the MAESTRO
monitor and store the file on a USB key.