Gentec-EO TUNER - Manual (Page 17)

TUNER User’s Manual Revision 4.2 16
Gentec Electro – Optics, Inc. All rights reserved
5 APPENDIX
5.1 Recycling and separation procedure
This section is used by the recycling center when the monitor reaches its end of life. Breaking the
calibration seal or opening the monitor will void the TUNER warranty.
The complete Monitor contains
1 Monitor
1 9 volt AC/DC adaptor (not manufactured by Gentec-eo)
4 AA Alkaline Batteries
1 CD Instruction manual
1 Calibration certificate
5.2 Separation
Paper : certificate.
Plastic: stand, connector plate, battery door, monitor enclosure, keypad.
Wires.
AA batteries: inside battery compartment.
Metal battery clips.
Printed circuit board: inside the monitor featuring a liquid crystal display less than 100 cm
2
.
5.3 Dismantling procedure
- Remove batteries.
- Remove the posts on each side of the DB15 connector using pliers.
- Open monitor by removing the Phillips head screws in the 4 corners.
- Cut the wires on the PCB side and battery clips side with cutters.
- Remove battery clips with pliers.
Internal #103142 Rev. C