Havener E-40 Edger User Manual
Page 8
8
Installing The Throttle Wire
1. Set the throttle control lever located on the right side of the handle in the “STOP” position.( Fig 2) Set the
throttle lever located on the right side of engine in the “SLOW” speed position. Remove air filter cover. Insert
throttle wire through the clamp then slide wire through wire holder. (Fig 1) Tighten screws and replace air
filter. Make sure the throttle fully opens and closes properly.
Fuel Specification
1. Follow fueling instructions in the engine manual.
DANGER: GASOLINE IS HIGHLY FLAMMABLE AND EXPLOSIVE. DO NOT ADD FUEL WHILE THE ENGINE
IS RUNNING OR IS HOT. KEEP OPEN FLAMES, SPARKS, AND HEAT AWAY FROM THE FUEL AND STORE
FUEL IN CONTAINERS SPECIFICALLY DESIGNED FOR THAT PURPOSE. ADD FUEL OUTDOORS ONLY.
REPLACE GAS CAP SECURELY AND WIPE UP ALL SPILLED FUEL.
2. Always clean area around fuel cap before removing it to prevent excessive amounts of dirt from entering
fueling system. Also insure that the fuel storage container you are using is clean and in good condition.
Engine Operation
CAUTION: Before starting engine, become totally familiar with all controls. Read this Operator’s
Manual thoroughly. Always check engine oil level before starting engine.
!
!
Clamp
Figure 1
Wire
Holder
Figure 2
Throttle
control lever