Lanair DHI 300 - Manual (Page 51)

BEFORE YOU BEGIN INSTALLATION...
IMPORTANT
Read and understand this manual completely before beginning installation.
• This heater is for commercial and industrial use only. This unit is not intended for residential
use.
• This heater must be installed and/or inspected by a licensed heating contractor
before operation. Installer should be trained and thoroughly familiar with the
installation and operation of oil-fired heaters.
• Installation of this unit must be made in accordance with state and local codes or authori-
ties having jurisdiction over environmental control, fuel, fire and electrical safety.
• N.F.P.A. (National Fire Protection Association Publications for Heater Installation)
NFPA No. 30 Flammable and Combustible Liquids Code
NFPA No. 31 Standard for the Installation of Oil Burning Equipment
NFPA No. 70 National Electric Code
NFPA No. 80 A&B Repair Garages and Parking Structures
NFPA No. 211 Standard for Chimneys, Fireplaces, Vents, and
Solid Fuel Burning Appliances
The above standards are available from the National Fire Protection Assn., Battery March
Park, Quincey, MA 02269
• Read and familiarize yourself with these instructions and associated photos, diagrams and
illustrations before beginning installation or operation. These instructions should be fol-
lowed closely, to achieve the best possible results.
If you have questions or concerns at any time during the installation, stop the installation
and contact a Lanair Service Representative.
• Check to make sure you have all the required components needed for proper installation
and operation.
• Check each component for visible damage. If you find a damaged component, contact a
Lanair Service Representative for a replacement. Do not install broken or damaged parts.
• This heater is designed to provide economically and environmentally friendly disposal of
waste oil. Due to the nature of the fuel used, this heater should not be relied upon as the
sole source of heat.
• Read and understand the warranty. Fill out the enclosed warranty card and return within
10 days of purchase.
QUESTIONS?... Contact Customer Service at 1-800-753-1601 M-F 8:00 am- 4:15 pm CST
2
Section 16 - Burner Reference Diagram
Visit our website at: www.lanair.com
51
Oil Pressure
Gauge
Manual
Reset &
Snap Disk
Fuel Supply
Pre-Heater
Adjustment
Screw
To Combustion
Blower
Pre-Heater
Switch
Ai
rS
up
pl
y
Air
Supply
Air
Solenoid
Ignitor
Oil
Pre-Heater
Block
Air
Pre-Heater
Block
To Oil Primary
To “F”
Terminals
To Transformer
Burner Cover
View Port
Cad Cell
El
ec
tri
ca
lQ
ui
ck
Di
sc
on
ne
ct