Ransburg AdaptaFlow Node Adapter A10159 - Manual (Page 13)

LN-9217-00.2
AdaptaFlow Node Adapter - Installation
An 82 ohm resistor is provided on the Interface Board to terminate the RIO cable. Where the RIO cable
is daisy-chained to more than one Node Adapter, only the last connection point in the daisy-chain should
be terminated by moving the associated switch to the “TERM” position.
Figure 5: Node Adapter Interface Figure 5: Node Adapter Interface Figure 5: Node Adapter Interface Figure 5: Node Adapter Interface Figure 5: Node Adapter Interface
From PLC I/O Cable From PLC I/O Cable From PLC I/O Cable From PLC I/O Cable From PLC I/O Cable
Blue
Shield
Clear
To Node Adapter To Node Adapter To Node Adapter To Node Adapter To Node Adapter
Interface (RIO) Interface (RIO) Interface (RIO) Interface (RIO) Interface (RIO)
BLU
SHLD
CLR
1 0 1 0 1 0 1 0 1 0
PLC Remote I/O Cable Connections PLC Remote I/O Cable Connections PLC Remote I/O Cable Connections PLC Remote I/O Cable Connections PLC Remote I/O Cable Connections
ARCHIVE