Securitron WSS - Manual (Page 2)

3 Precautions
4 Installation/Wiring/Setup
☐ Shut off power to power source before attempting any wiring procedures.
☐ Maintain a clean and safe environment when working in public areas.
☐
☐
unexpected reactions by the door.
☐ Observe proper protocols for circuit board handling to protect the unit from electrostatic discharge.
Before handling any board ensure you dissipate your body’s charge.
☐ Check placement of all wiring before powering to ensure that moving door parts do not
catch wires and cause damage to equipment.
☐ Ensure compliance with all applicable safety standards (i.e. ANSI A156.10/A156.19) upon
completion of installation.
☐ DO NOT attempt any repair of the sensor. Unauthorized disassembly or repair:
1. May jeopardize personal safety and may expose one to the risk of electrical shock.
2. Will void the product warranty.
1 Installation
Mounting
Ring
Gang
Box
or
WSS
Assembly
Mounting
Ring
Gang
Box
or WSS
Assembly
Adapter Ring
Foam Gasket
1. The WSS may be mounted using the included mounting
ring or in a standard plastic or metal electrical gang
boxes. Do not allow contact between the sensor and
a metal gang box to prevent shorting the devices. Be
sure to place the device so that motion from the door
or other types of movement do not interfere with the
detection zone.
2. Depending on the door installation, the weather resistant
foam gasket or the plastic adapter ring may be used.
The weather resistant foam is used as a protective
barrier against the elements. The plastic adapter ring is
designed to enable the double gang face plate to attach
to various plastic and metal gang boxes.
2 Wiring
● PWR: Black - 12 to 24 VAC/VDC: -5% to +10%
● PWR: Red - 12 to 24 VAC/VDC: -5% to +10%
● NC: Empty - NC Contact
●
NO: Green - NO Contact
●
COM: White - Common at Door Control
W
S
S
C
O
N
T
R
O
L
NC NO COM POWER NC NO COM POWER
B
lack - 12
to
24
V
A
C / VD
C
Red - 12 to
24
V
AC / VD
C
White - Com a
t
Door Control
Green - NO Cotact Empty - NC
Conta
ct
1. Wire the 4-conductor cable as shown above. 2. Attach the 4-conductor cable connector to the WSS
as shown.
500-23700_A