Harrington Hoists and Cranes GT Trolley - Manual (Page 30)

1) Remove the top pin, yoke and top hook.
2) To remove the top pin, yoke and top hook on the TCR1000P loosen and remove the 3 bolts holding the
gear section onto the main body. Rotate the gear section clockwise to allow the top pin to be removed.
3) Place the suspender on the top of the hoist. Line up the holes for the hoist main body and suspender.
Reinsert the top pin.
4) Reassemble the remaining hoist components in reverse order of disassembly.
For Double fall hoists (TCR1000P2, TCR2000P2, TCR6000P2) - Refer to Figure 3-25.
Remove the Top Hook Assembly and Load Chain from the hoist and install the suspender as follows:
1) Loosen and remove the bolt attaching the load chain to the top hook yoke.
2) Remove the load chain from the top hook yoke.
3) Remove the top pin, yoke and top hook.
4) To remove the top pin, yoke and top hook on the TCR2000P2 loosen and remove the 3 bolts holding the
gear section onto the main body. Rotate the gear section clockwise to allow the top pin to be removed.
5) Place the suspender on the top of the hoist. Line up the holes for the hoist main body and suspender.
Reinsert the top pin.
6) Reassemble the remaining hoist components in reverse order of disassembly
7) Reattach the no load side of the load chain to the load chain mounting hole in the suspender.
For Double fall hoist (TCR10000P2) - Refer to Figure 3-26
Remove the Top Hook Assembly from the hoist and install the suspender as follows:
1) Loosen and remove the two top pins that connect the top hook assembly to the hoist body.
2) Remove the top hook assembly.
3) Place the suspender on the top of the hoist and line up the holes with the main hoist body.
4) Reinstall the two top pins through the hoist body and suspender.
30