NewAir Portabile Air Conditioner AC-10000H - Manual (Page 11)

DRAINING THE UNIT
During the cooling process, some water will be extracted from the air and stored within the
unit’s water reservoir.
If the water reservoir is full, both the compressor and motor will stop and the unit will beep
(press any button to stop the beeping sound). The full water tank indicator light will also
start flashing.
To resume cooling, empty the reservoir by following these steps:
1. Turn off the air conditioner and unplug it
from the wall socket. To prevent water
leakage, avoid moving the unit when full.
2. Place a container (such as a small pan)
underneath the drainage port.
3. Remove the water plug from the drainage
port and allow the water to drain out.
4. When the container is almost full, replace
the water plug back into the drainage port
and empty the water container.
5. Repeat until the water reservoir is
completely empty.
6. Replace the water plug back into the
drainage port and make sure it is firmly in
place.
7. Turn the unit back on. The warning signal
should be off.
Water plug
Cap for the
water plug
Drainage port
FIG.17
For Continuous Drainage
•
Remove the water plug from the drainage
port and retain it for future use.
•
Connect the drainage hose included with
unit to the drainage port as shown.
Connect the other end of the hose into a
drain.
FIG.18
Water plug
Cap for the
water plug
10