11 appendix a – generation script example, 1 example script 1, Appendix a – Teledyne LeCroy Voyager Exerciser Generation Script Language Manual User Manual

Page 142: Generation script example, Example script 1

Advertising

Teledyne LeCroy

Voyager USB 3.0 Exerciser Generation Script Language Reference Manual

133

11 Appendix A

– Generation Script Example

Note: You can find more examples in the USB Protocol Suite application folder.

11.1 Example Script 1

############################################################################
# NewGenSettings.usb3g

# Line comment

/*
Block comment
*/

# General constant

const

INFINITE =

0xFFFFFFFF

const

AUTO =

0xFFFFFFFF

############################################################################
# This generaton script contains new or modified generation settings
# since the previous release of the Lecroy USB Suite.
#
# For all the other settings please refer to
# Voyager™ USB 3.0 Exerciser Generation Script Language Reference Manual
# contained in the VoyagerUSB3ExerciserScriptLanguage.pdf.
#
# NOTE: All generation setting examples are for illustration purposes only.
# Change settings from default values ONLY if you understand them.
############################################################################

##########################################################################
# Some Link management settings

# Power state accept flags

const

AU1 =

0x1

# Accept the request of entering U1 by sending LAU.

const

AU2 =

0x2

# Accept the request of entering U2 by sending LAU.

const

AU3 =

0x4

# Accept the request of entering U3 by sending LAU.

const

AU_AUTO =

0x8

# AUTO mode. Reply to the LGO_Un based on the

# configured value through LMPs.

const

AU_ALL = (AU1 | AU2 | AU3)

# This setting controls the behavior of the device in response to
# Power Management states entry request (LGO_Un).

Set

PwrStateAccept = AU1

# Accept only U1

# This setting enables/disables sending of LPMA in response to LAU.

Set

DisableLPMA =

# disables sending of LPMA in response to LAU.

# If the appropriate response in LC handshake of Power State change
# has not be received during specified timeout, this error will be raised.
# This setting allows not to raise such error in the Exercizer link layer.

Set

DisablePMLCTimeout =

# Disables detection of timeout on receiving

# response to PM Link command.

Advertising