Warner Electric ARC Clutch_ZRC Top Load - Manual (Page 8)

8 Warner Electric • 800-825-9050 P-2019 • ARC
Press bearing out of housing using FIX-0002 and an
arbor press. See FIgure 29.
Figure 29
Turn housing over. Press new bearing in housing
using FIX-0002 and an arbor press. See Figure 30.
Figure 30
Separate magnet stack and clean all magnets –
replace as required. Use an alcohol based cleaning
solvent to clean the black driver magnets. Do not
use anything abrasive when wiping the black driver
magnets. Use a Scotch Brite deburr wheel to polish
the hysteresis magnet. See Figure 32.
Figure 32
Put in new seal. See Figure 31.
Figure 31
FIX-0002
FIX-0002
To replace the magnet on end cap, break the
magnet with a hammer. Remove broken magnet
pieces and old screws. Install new magnet and new
screws. Epoxy magnet holes with epoxy packet from
rebuild kit. Make sure epoxy does not build up on
surface of magnet more than .010” (0.25mm). See
epoxy instructions below (Figure 34)
Figure 33
Install magnet plate into housing. Line up any three
holes and insert screws. See Figure 35.
Figure 35
Tighten the three socket head cap screws with a
9/64” 3mm hex wrench. See Figure 36
Figure 36
Figure 34