Waterstone Diverter 4400, 4410 Gantry Series - Manual

Diverter Replacement
4400, 4410 Gantry Series Faucets
WATERSTONE
1- Turn off water supply to faucet.
2- Unscrew retainer nut (a) until disengaged from thread.
Note: The diverter may be located on either side or in front or back.
3- Carefully swivel the spout assembly (b) back and forth while
lifting up just until the retaining screw (c) is accessible with a
screw driver, this will allow the assembly to “rest” without putting
pressure on the faucet’s finish.
4- Remove the diverter retaining screw (c).
Using a needle nose pliers or small hook, remove the old diverter
by pulling it straight out.
5- Insert the new diverter by pushing straight in (use a little liquid
soap to lubricate the o-rings before installation), make sure the
set of 6 ”half-holes” are pointing out.
6- Re-install the retainer screw (c). Swivel the spout assembly
back down and tighten the retaining nut by hand.
7- Check for leaks and proper operation of the spray.
a
c
b
Diverter
c
Diverter
Diverter replacement
4400, 4410 Gantry
®
series faucets.
41180 Raintree Court // Murrieta, CA 92562 // 1-888-304-0660
MADE IN THE USA www.waterstoneco.com