IEI Integration KINO-G410 v1.03 - Manual (Page 56)

KINO-G410 Mini-ITX Motherboard
Page 44
4.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The KINO-G410 includes one jumper shown in Table 4-1.
Description Label Type
Clear CMOS jumper J_CMOS1 3-pin header
COM6 function select jumper JP2 8-pin header
Table 4-1: Jumpers
4.4.1 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-8
To reset the BIOS, move the jumper to the "Clear BIOS" position for 3 seconds or more,
and then move back to the default position.