5 internal peripheral device connections, 1 sata drive connection, Nternal – IEI Integration KINO-CVR-D25502_N26002 User Manual
Page 58: Eripheral, Evice, Onnections, Figure 4-3: at/atx mode select jumper location, Table 4-2: at/atx mode select jumper settings, Ee table 4-2, Ee figure 4-3
KINO-CVR-D25502/N26002
P a g e 46
The AT/ATX mode select jumper specifies the systems power mode as AT or ATX.
AT/ATX mode select jumper settings are shown in Table 4-2.
Setting
Description
Open
AT Mode
Short
ATX Mode
Default
Table 4-2: AT/ATX Mode Select Jumper Settings
The location of the AT/ATX mode select jumper is shown in Figure 4-3 below.
Figure 4-3: AT/ATX Mode Select Jumper Location
4.5 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the on-board connectors
4.5.1 S ATA Drive Co n n e c tio n
The KINO-CVR-D25502/N26002 is shipped with two SATA drive cables and one SATA
drive power cable. To connect the SATA drives to the connectors, please follow the steps
below.
S te p 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.