IEI Integration IMB-C2060 v1.03 - Manual (Page 77)

IMB-C2060 microATX Motherboard
Page 63
4.5.3 Parallel Device Connection
The IMB-C2060 has a single female DB-25 connector on the external peripheral interface
panel for parallel devices. Follow the steps below to connect a parallel device to the
IMB-C2060.
Step 1: Locate the DB-25 connector. The location of the DB-25 connector is shown in
Chapter 3.
Step 2: Insert the DB-25 connector. Insert the DB-25 connector of a parallel device
into the DB-25 connector on the external peripheral interface. See Figure 4-16.
Figure 4-16: Parallel Device Connector
Step 3: Secure the connector. Secure the DB-25 connector to the external interface by
tightening the two retention screws on either side of the connector. Step 0:
4.5.4 PS/2 Keyboard and Mouse Connection
The IMB-C2060 has a dual PS/2 connector on the external peripheral interface panel. The
dual PS/2 connector is used to connect to a keyboard and mouse to the system. Follow
the steps below to connect a keyboard and mouse to the IMB-C2060.