IEI Integration NANO-945GSE2 - Manual (Page 63)

NANO-945GSE2
Page 49
Jumper Label: ATXCTL1
Jumper Type: 2-pin header
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-3
The AT Power Select jumper specifies the system’s power mode as AT or ATX. Use a
jumper cap to short pins 1 and 2 to enable the AT Power mode. In the ATX mode use the
PS_ON- and 5VSB cable. AT Power Select jumper settings are shown in Table 4-2.
AT Power Select Description
Short 1 – 2 Use AT power Default
Open Use ATX power
Table 4-2: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 4-3 below.
Figure 4-3: AT Power Select Jumper Location