B.2.5 create factory default image, Figure b-6: press any key to continue, Figure b-7: press f3 to boot into recovery mode – IEI Integration NANO-PV-D4252_N4552_D5252 User Manual
Page 124
NANO-PV-D4252/N4552/D5252 EPIC SBC
Page 110
Step 6:
After completing the system configuration, press any key in the following window
to reboot the system.
Figure B-6: Press any key to continue
Step 7:
Eject the recovery CD.
S
te
p
0
:
B.2.5 Create Factory Default Image
NOTE:
Before creating the factory default image, please configure the system
to a factory default environment, including driver and application
installations.
To create a factory default image, please follow the steps below.
Step 1:
Turn on the system. When the following screen displays (Figure B-7), press the
<F3> key to access the recovery tool. The message will display for 10 seconds,
please press F3 before the system boots into the operating system.
Figure B-7: Press F3 to Boot into Recovery Mode
Step 2:
The recovery tool menu appears. Type <4> and press <Enter>. (Figure B-8)