IEI Integration WAFER-945GSE v1.03 - Manual (Page 24)

WAFER-945GSE 3.5” Motherboard
Page 4
1 x Power button connector
1 x Reset button connector
1 x 4-port RS-232 serial port connector
1 x RS-232/422/485 serial port connector
2 x Serial ATA (SATA) drive connectors
2 x USB 2.0 connectors (supports four USB 2.0 devices)
The WAFER-945GSE has the following external peripheral interface connectors on the
board rear panel.
2 x Ethernet connectors
1 x Serial port connector
2 x USB connectors
1 x VGA connector
The WAFER-945GSE has the following on-board jumpers:
AT Power Mode Setting
Clear CMOS
CF card setup
LVDS1 Voltage Selection
LVDS1 Panel Resolution Selection
COM2 Port Mode setting
1.2.3 Technical Specifications
WAFER-945GSE technical specifications are listed in
747H709H
Table 1-1. See Chapter 2 for
details.
Specification WAFER-945GSE
Form Factor 3.5”
System CPU 45 nm 1.6 GHz Intel® Atom™ N270
Front Side Bus (FSB) 533 MHz