Install odd, Front panel cable connections – IEI Integration EBC-3100 User Manual
Page 6

EBC-3100 IEI Technology Corp. Page 6
Figure 10: HDD/ODD Bracket Retention Screws
INSTALL ODD
To install an ODD, please follow the steps below.
Step 1:
Attach the new ODD to the ODD bracket. Align the
four retention screw holes in both sides of ODD with
the retention screw holes on the side of the ODD
bracket. Insert the four retention screws into the
bracket on both sides of the ODD (Figure 11).
Figure 11: ODD Retention Screws
Step 2:
Attach the SATA cable to the ODD by aligning the
two retention screw holes in the SATA cable with the
retention screw holes on the rear of the ODD. Insert
two retention screws into the SATA cable (Figure
12).
Figure 12: SATA Cable Retention Screws
Step 3:
Reinstall the ODD bracket into the EBC-3100 by
aligning the retention screw holes in the top of the
ODD bracket with the retention screw holes on the
chassis. Reinsert the four previously removed
retention screws into the ODD bracket
Step 4:
Reconnect the SATA and power cable connectors
from the rear of ODD to the motherboard.
Step 0:
FRONT PANEL CABLE CONNECTIONS
The following buttons and LEDs are on the front panel of the EBC-3000
chassis.
1 x Power LED
1 x HDD LED
1 x Power switch
1 x Reset button
These components are all connected to the SBC with cables. To correctly
connect these cables, please refer to the technical documentation that
came with your SBC. The connectors that are provided with the chassis
are listed below.
No. Name
1
Power LED cable
1
Reset Switch cable
1
HDD LED cable
1
Power switch cable
Table 6: Chassis Connectors