IEI Integration AFL-ххA-N26 - Manual (Page 34)

AFL-xxA-N26 Series Panel PC
Page 34
ƒ Anti-static Discharge: If a user open the rear panel of the flat panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the flat panel PC
Step 2: Install a mSATA SSD card
Step 3: Install a HDD (AFL-12A-N26 only)
Step 4: Configure the system
Step 5: Connect peripheral devices to the bottom panel of the flat panel PC
Step 6: Mount the flat panel PC Step 0:
3.4 Opening the System
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-xxA-N26 internally the back cover and the internal aluminum cover
must be removed. To remove the covers, please follow the steps below.
Step 1: Remove the retention screws (Figure 3-1) and lift the back cover off the flat
panel PC.