IEI Integration AFL-F08A v2.40 - Manual (Page 37)

AFL-F08A-N270 Panel PC
Page 22
Figure 3-7: AT/ATX Power Selection Switch
3.7.4 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 2-pin header
Jumper Settings: See
77
Table 3-3
Jumper Location: See
77
Figure 3-8
If the AFL-F08A-N270 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ Enter the correct CMOS setting
ƒ Load Optimal Defaults
ƒ Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.