Lincoln Electric IM10155 SAE-300 HE - Manual (Page 12)

A-5
INSTALLATION SAE-300 ® HE
PRE-OPERATION SERVICE
READ the engine operating and maintenance
instructions supplied with this machine.
OIL
This unit is supplied from the factory with the engine crankcase
filled with a high quality SAE 10W/30 oil. This oil should be
acceptable for most typical ambient temperatures. Consult the
engine operation manual for specific engine manufacturer’s rec-
ommendations. Upon receipt of the welder, check the engine
dipstick to be sure the oil is at the “full” mark. DO NOT overfill.
FUEL
Fill the fuel tank with the grade of fuel recommended in the
Engine Operator’s manual. Make sure the fuel valve on the water
separator is in the open position.
COOLING SYSTEM
The radiator has been filled at the factory with a 50-50 mixture
of ethylene glycol antifreeze and water. Check the radiator level
and add a 50-50 solution as needed (see engine manual or
antifreeze container for alternate antifreeze recommendations).
POLARITY CONTROL AND CABLE SIZES
With the engine off, route the electrode and work cables through
the strain relief bracket on the base and connect to the studs
located below the fuel tank mounting rail. (See size recommen-
dations below.) For positive polarity, connect the electrode
cable to the terminal marked “+”. For Negative polarity, con-
nect the electrode cable to the “-” stud. These connections
should be checked periodically and tightened if necessary.
When welding at a considerable distance from the welder, be
sure you use ample sized welding cables.
RECOMMENDED COPPER CABLE SIZES
Cables Sizes for Combined Length
of Electrode Plus Work Cable
Amps Duty Cycle Up to 200ft.(61m) 200 to 250ft.
(61 to 76m)
250 100% 1 1/0
300 60% 1/0 2/0
VEHICLE MOUNTING
Improperly mounted concentrated loads may cause unstable
vehicle handling and tires or other components to fail.
• Only transport this Equipment on serviceable vehicles
which are rated and designed for such loads.
• Distribute, balance and secure loads so vehicle is stable
under conditions of use.
• Do not exceed maximum rated loads for components
such as suspension, axles and tires.
• Use appropriate nuts bolts and lockwashers to attach the
equipment base to the metal bed or frame of vehicle.
• Follow vehicle manufacturer’s instructions.
• Stop engine while fueling.
• Do not smoke when fueling.
• Keep sparks and flame away from tank.
• Do not leave unattended while fueling.
• Wipe up spilled fuel and allow fumes to
clear before starting engine.
• Do not overfill tank, fuel expansion may
cause overflow.
DI ESEL FUEL ONLY-Low sulphur fuel or
u l t r a l o w s u l p h ur f u el i n U.S.A . a n d
Canada.
DIESEL FUEL
can
cause fire
CAUTION
WARNING
WARNING