Lincoln Electric IMT10135 WIRE FEEDER WELDER 180 - Manual (Page 7)

A-1 A-1
INSTALLATION
WIRE FEEDER WELDER (180 MODEL)
OPERA
T
OR
ʼS
MANUAL
TECHNICAL SPECIFICATIONS 180 Amp units (K2481-1, K2515-1, K2659-1, K2698-1)
INPUT – SINGLE PHASE ONLY
RATED OUTPUT
OUTPUT
Standard Voltage/Frequency Input Current
230 V 60 Hz 20 Amps @ rated output
208 V 60 Hz 20 Amps @ rated output
Voltage/Duty Cycle Current Voltage at Rated Amperes
230 V 30% 130 Amps 20
208 V 30% 130 Amps 17.6
Welding Current Range Open Circuit Voltage Wire Speed Range
30-180 Amps 34 V 50 - 500 in/min.
(1.3 - 12.7 m/min.)
Input Voltage/Frequency Fuse or Breaker Size 1 Input Amps Minimum Input Cable
230/208 V 60 Hz 40 Amp Super Lag 20 14 AWG
RECOMMENDED INPUT CABLE AND FUSE SIZES
Height Width Depth Weight
13.7 in 10.15 in 18.2 in 56 Ibs
347 mm 258 mm 462 mm 25.4 kg
PHYSICAL DIMENSIONS
1 If connected to a circuit protected by fuses use Time Delay Fuse marked “D”.
SELECT SUITABLE LOCATION
Locate the welder in a dry location where there is free
circulation of clean air into the louvers in the back and
out the front of the unit. A location that minimizes the
amount of smoke and dirt drawn into the rear louvers
reduces the chance of dirt accumulation that can
block air passages and cause overheating.
STACKING
WIRE FEEDER WELDER(180 MODEL) cannot be
stacked.
TILTING
Each machine must be placed on a secure, level sur-
face, directly or on recommended cart. The machine
may topple over if this procedure is not followed.
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• Only qualified personnel should
perform this installation.
• Only personnel that have read and
understood the WIRE FEEDER
WELDER Operating Manual should
install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local or
other applicable electrical codes.
• The WIRE FEEDER WELDER power switch is
to be in the OFF (“O”) position when installing
work cable and gun and when connecting
power cord to input power.
---------------------------------------------------------------------
WARNING