Ramsey Winch ATV 2500 ROCKER SWITCH 256117 - Manual

INSTALLATION INSTRUCTIONS
FOR REPLACEMENT ROCKER SWITCH KIT #256117
FOR ATV WINCH WITH REMOTE MOUNTED MANUAL SWITCH
1
SOLENOID ASS’Y.
BLACK W/ YELLOW
STRIPE MOTOR
LEAD
RED
BATTERY LEAD
BLACK
BATTERY LEAD
BATTERY
YELLOW WIRE
BLACK MOTOR
LEAD
GREEN WIRE
RED WIRE
ROCKER SWITCH
#1
MOTOR
#2
NOTE:
TORQUE SOLENOID
TERMINAL NUTS TO
35-40 IN-LBS.
E A
C
B
TO ATV IGNITION
SPLICE
Electrical Schematic
Before Beginning Installation
1. Locate Remote Mounted Switch and Solenoid and disconnect all wiring to battery and
winch. Switch and Solenoid can be removed and discarded.
2. Disconnect negative (-) battery cable from battery. Turn off vehicle ignition.
3. Disengage winch clutch.
4. Remove hood or cowling as necessary for easier access to installation area.
5. Locate and mark mounting location for Solenoid Assembly.
6. Locate accessory wire from vehicle ignition switch that is powered only when ignition is ON. Use
this wire when splicing to Red wire on Rocker switch.
7. Make sure locations are close enough for wiring connections to be made without making alterations
to wire lengths.
IN
OUT