Rapid-Air SERVO FEED WITH CUT-TO-LENGTH: 100, 200 & 300 SERIES - Manual (Page 3)

2
RAPID-AIR START UP SECTION
SERVO FEED—CUT TO LENGTH
100, 200, 300 Series
Rev. C
Congratulations on purchasing a Rapid-Air Servo Cut-To-Length. Not only did you
receive a complete servo unit but also telephone support by one of our engineering
staff to guide you on using the new servo to its maximum capability.
In order to maximize your learning time and trouble shoot any interface problems, we
would like to request that the following items be complete before calling us:
1. Servo unit should be completely installed and aligned to a die on the press.
2. 220 Vac electrical wiring should be in place and unit turned on.
3. All interface switches should be wired and tested.
4. Air if needed should be connected and ready to be used.
5. All servo interface questions should be directed to Rapid Air prior to a start-up visit.
Please call 815-397-2578 and ask to have these questions directed to the proper
personnel.