Maple Systems MAP450D - Manual (Page 16)

Cursor Type Setting
This parameter determines the type of cursor used in the OIT’s display. Options are No
Cursor and Underline.
Factory Default: Underline
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the desired cursor type in the
Cursor Type list box.
To modify this parameter in Configuration mode:
1. At Cursor:, use the OIT’s Period (.) key to select the desired cursor type. Refer to the
Configuration Mode section in this chapter for more information.
To modify this parameter from the host controller:
1. Use the Display and Cursor Format control command. Refer to Appendix A: Control
Commands for more information.
Wrap Around Setting
This parameter determines whether the OIT will use ‘word wrapping’ when displaying
characters on the OIT screen. If disabled, any characters received from the host or from
the keyboard of the OIT are displayed on the OIT screen at the location of the cursor. If
the cursor is on the last column of a line, then the incoming character overwrites any
character that is currently displayed on the last column and the cursor does not move.
If the wrap around feature is enabled, then the cursor will drop down to the beginning of
the next line when it reaches the end of the current line.
Note: The OIT does not support the wrap around feature when the operating mode is in Block
or Network mode and the character to be displayed comes from a keypress on the OIT.
Factory Default: Disabled
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the Wrap Around check box.
To modify this parameter in Configuration mode:
1. At WrapAround:, use the OIT’s Period (.) key to enable or disable the Wrap Around
feature. Refer to the Configuration Mode section in this chapter for more
information.
To modify this parameter from the host controller:
1. This feature cannot be changed from the host controller.
15 MAP450D Operation Manual
1010-0101, Rev. 00