Yokogawa SPS24 - Manual (Page 9)

<1. Introduction>
1-3
IM 12A01S02-01E 1st Edition : May 10, 2013-00
1.2.1 Connection Information Field
The connection information field displays the status and information of connected sensors, and
can also be used for switching target sensors.
Sensors can be connected or disconnected by clicking on the [Connect] or [Disconnect] buttons
at the bottom of the field.
Toggle between wide/narrow display
Connected sensor button
Sensor not connected
Target sensor
for calibration
Target sensor
for display
Model (SensorType)
Sensor number
ID(Serial No.)
Comments
Figure 1.3 Screen example of connection information field
When “Sensor Not Connected” is shown despite a sensor being connected, disconnect the
sensor from the cable, reconnect, and click [Connect] again.
Information about the connected sensor is displayed on the sensor connection button along with
the connection status.
The sensor type can be set using [Sensor setup] (pH, ORP, pH+ORP).
An optional comment can be entered for sensor identification using [Database viewer] – [Edit
data].
When the display shows the following icons, see “5. Error Information”.
1.2.2 Toolbar
The toolbar has function switch buttons for [Sensor management], [Database viewer], [Error
information], [Setup], and others. Clicking a button displays the corresponding function screen.
For details, see sections 3 to 7.
This operation is also available from [View] on the menu bar.