Automatic model determination, Communication retry operation, Port settings – Yokogawa DAQWORX User Manual

Page 23: Automatic model determination -3, Communication retry operation -3, Port settings -3, Index, Automatc model determnaton, Communcaton retry operaton, Port settngs

Advertising
background image

3-3

IM WX1-08E

1

2

3

Index

Deta

ls of Funct

ons

Automatc Model Determnaton

If you select a recorder (µR10000/µR20000) on the software and perform automatic

model determination, the recorder model, type, number of measurement channels, and

number of computation channels are applied to the Recorder Settng tab.

Model and Number of Channels

Model

Type

No of meas ch

No of calc ch

µR10000/µR20000/SR10000

Pen

1

8

1

µR10000/µR20000/SR10000

Pen

2

8

1

µR10000/µR20000/SR10000

Pen

3

8

1

µR10000/µR20000/SR10000

Pen

4

8

1

µR10000/µR20000/SR10000

Dot

6

12

1

µR20000

Dot

12

24

µR20000

Dot

18

24

µR20000

Dot

24

24

1 The SR10000 does not have MATH channels.

Scan Interval

A scan interval from 0.5 to 3600 seconds can be selected for each of the sixteen

recorders.

Note

When connecting to DAQLOGGER and acquiring data from the recorder, if Gate µR’s scan

interval is longer than that of DAQLOGGER, DAQLOGGER logs the same data as is within the

Gate µR scan interval. Therefore, it is recommended that Gate µR’s scan interval be set to a

value smaller than DAQLOGGER’s scan interval.

Communcaton Retry Operaton

You can turn communication retry ON and OFF, and set the retry interval.

• When Turning Communication Retry OFF

After detecting that communications were broken, it is not reconnected.

• When Turning Communication Retry ON

After detecting that communications were broken, the software attempts to reconnect

after the retry interval has elapsed. Even if the reconnection resulted in an error,

the software waits again for the retry interval to elapse, then attempts another

reconnection. This process repeats until a valid connection is opened.

A communication retry interval of 30 to 3600 seconds can be entered.

Retries are also performed on instruments with which a communication error occurred
during the first communication. At the point that communication is restored, the
decimal place, alarm values, and other necessary information are retrieved from the
μR, and data is acquired.

Note

This software considers communications to have been cut in the following circumstances.

• If the software requests data from the recorder but no response is received within ten

seconds.

• If a TCP/IP connection is detected or if login fails when attempting to connect to the recorder

via Ethernet.

Port Settngs

The following port settings can be entered using the software.

• Monitor server port

The TCP/IP port number used for communication with DAQLOGGER or Remote

Monitor.

3.2 Detals of Functons

Advertising
This manual is related to the following products: