UView MiST II In-Car Air Quality System - Manual (Page 8)

– 7 –
Climate Control
Adjust climate control to
ALL of the following settings.
Settings may differ between
vehicle makes and models.
Check owner’s manual for
proper climate control
operations.
Power Machine
Ensure vehicle is running and A/C
is turned “ON”.
Connect 12V DC connector into
the vehicles 12V system. (Photo D)
All indicator lights will illuminate
then turn off within 2 seconds.
Power indicator light
will illuminate. (Photo E)
Press RED Start button.
In-Progress indicator light
will illuminate. (Photo F)
3 4
Set fan to
HALF SPEED
Set temperature
to 72˚F / 22˚C
˚F/˚C
C
Set air-flow to
DASH VENTS
ONLY
H
Set to
RECIRCULATE
or MAX A/C
Turn ON A/C
Typical Climate Controls
What it Means Corrective Action
Fluid is too full - machine
not drained properly
Machine not level
Drain machine completely and refill
To drain - tilt forward; fill using new fluid container
Make sure machine is sitting on flat surface
Use positioning level - bubble in the center
Disconnect from power and reconnect
Service time was less than
8 minutes (normal cycles is
approx. 14 min at 72°F/22°C)
Low fluid level
Machine not level
Drain machine completely and refill
To drain - tilt forward; fill using new fluid container
Make sure machine is sitting on flat surface
Use positioning level - bubble in the center
Disconnect from power and reconnect
Component failure Reset machine
Disconnect from power and reconnect
Contact customer service if problem persists
Ambient temperature
inside vehicle is above
120°F/50°C
Adjust interior vehicle temperature
Adjust climate control (run A/C) to lower temp to
72°F/22°C
Disconnect from power and reconnect
(LEDs flashing)
High current OVER 5 amps. Reset machine
Disconnect from power and reconnect
Contact customer service if problem persists (LEDs flashing)
Service time exceeded
18 minutes (normal cycle is
approx. 14 min at 72°F/ 22°C)
Ambient temperature
inside vehicle is lower
than 50°F/10°C
Fluid temperature is
lower than 50°F/10°C
(LED flashing)
Customer Service Department:
1-905-615-8620 or Toll Free 1-877-776-8486 (within North America)
or by email at [email protected]
www.uview.com
D
Sufficient cleaning solution has been used to warrant
a full service. Drain machine completely to prepare
for next service
To drain - tilt forward; fill using new solution container
Store cleaning solution at room temperature
Adjust interior vehicle temperature
Adjust climate control to increase temp to 72°F/22°C
Disconnect from power and reconnect
E
F (All LEDs flashing)