NcSTAR D3ARSGQLR2 - Manual (Page 5)

 DANGER: AVOID DIRECT EYE EXPOSURE TO THE LASER BEAM. LASER RADIATION
IS EMITTED FROM THE APPERTURE.
 CAUTION: AVOID SHINING THE LASER IN YOUR EYES, AND THE EYES OF OTHERS
AROUND YOU. THE LASER EMISSIONS CAN CAUSE SERIOUS INJURY TO THE EYE
INCLUDING BLINDNESS
ZEROING YOUR RED LASER SIGHT
ADJUSTING THE LASER WINDAGE AND ELEVATION:
The integral Red Laser is adjustable for both Windage and Elevation. The Laser’s Windage
Adjustment Set Screw and Laser’s Elevation Adjustment Set Screw are both found on the Optics
Front Housing. The Adjustment Set Screws can be adjusted by using the provided 2.0 mm Allen
Wrench.

To adjust the Laser Elevation Up, turn the Laser Elevation Adjustment Set Screw Counter-
Clockwise, and to adjust the Laser Elevation Down turn Laser Elevation Adjustment Set
Screw Clockwise.

To adjust the Laser Windage Right, turn the Laser Windage Adjustment Set Screw
Clockwise. To adjust the Laser Windage Left, turn the Laser Windage Adjustment Set Screw
Counter-Clockwise.
 NOTE: FOR ZEROING/SIGHTING IN YOUR RED LASER, PLEASE USE THE SAME
INSTRUCTIONS ABOVE TITLED SIGHTING IN YOUR GREEN DOT SIGHT.
BATTERY INSTALLATION
Your Green Dot Optic with Integrated Red Laser comes ready to use with a
pre-installed CR123A battery. If the Laser or the Green Dot no longer
illuminates, follow these simple instructions to replace the battery.
1. The Battery Compartment & Cap is located in the Optic’s Front
Housing, next to the Laser aperture.
2. To remove this Battery Cap, grasp the knurled edge of the Battery
Cap firmly with one hand and twist it Off Counter-Clockwise.
3. Remove the old battery and dispose of it properly. Replace it with a
New 3 volt Lithium CR123A Battery. Place the new CR123A Battery
in the Battery Compartment with the Positive “+” terminal facing out
towards the Battery Cap. Twist the Battery Cap Clockwise back onto
the Battery Compartment and hand tighten. Avoid using tools (such
as pliers) to perform this procedure as this may cause damage to
the unit.
 CAUTION: USE ONLY BRAND NEW 3 VOLT LITHIUM CR123A TYPE BATTERIES FOR
THIS OPTIC. USING ANY OTHER TYPE OF BATTERY MAY DAMAGE THE OPTIC.