NcSTAR AQPFLS - Manual (Page 4)

Dismounting
To dismount you’re Tactical Flashlight/Laser: Grasp the Main Body (2) and depress the Weaver
Style Quick Release Tab (5). Slide the unit forward until it has cleared the rail on the firearm
completely. Your Tactical Flashlight/Laser is now dismounted.
 WARNING: The Tactical Flashlight/Laser will securely mount on most weaver/picatinny rails,
but not all (depending on the location of the cross-slots on the rail itself).
Switch Operation
Once you have your Tactical Flashlight/Laser mounted, it is very quick and convenient to turn it on
and off. On the rear of the Main Body (2) you will notice a large On/Off Switch (3) and a small
Selector Switch (4). The two switches are used in conjunction with one another. If the On/Off
Switch (3) is flipped to the left, then it will turn the unit on continuously. If the On/Off Switch (3)
is pushed to the right, then it will turn on the unit so long as pressure is applied. As soon as
pressure is released, the unit will turn off. The Selector Switch (4) has three settings. With the
On/Off Switch (3) in the “on” position, the Selector Switch (4) can be flipped to the left to turn the
laser on only. The Selector Switch (4) can then be flipped to the middle position to turn on the
flashlight only, and then flipped to the right to turn on both the laser and the flashlight. If the unit
will not illuminate, check to make sure that the batteries are installed in the proper direction. To
conserve the life of the batteries, be sure that the unit is in the off position when not in use. If
you plan on storing the unit for a long period of time it is best to remove the batteries and set
them aside.